Hive back to Honeywell

[Cepheus1]

Apologies if this has been covered before, but despite a search of the forums I can't find the exact answer that I need.

I'm moving out of a rented property and am obligated to return it in the same state it was originally rented. This means that I need to remove my Hive "stuff" and refit the Honeywell T40 "stuff".

Re-fitting the heating/water controls has been straight-forward, but the thermostat is confusing me.

If someone could give me idiot proof guidance on which terminal each of the wires needs to go, I'd be extremely grateful.

 

[Steelmasons]

You really need to check voltage at each core due to the earth/neutral being used as switched lives in the case of MOMO valves being used (motor on motor off)..
Usually the red core would terminate at term 1.
Yellow core @ term 3.
Blue core/neutral @ term 2.