DAZB's latest activity

I was under the impression it was similar to a gas meter unit door and was just a simple lever type, a photo would clear it up a bit for...

You could try a long flat screwdriver in there to see if it will rotate or shape a length of timber to match the opening and see if that...

It's all about control of the water and i never use more than a trickle. The electrics and motor are at the back of the machine and...

Foam should do the job and i would move the wires out of harms way first and make the first burst of foam a good one so it gets to the...

I have the same saw and all i do is trickle a hose pipe onto the blade while cutting. Does the same job and just a slow trickle is all...

ok.... you may just need to drill a hole in the guard to fit this but easily done. Others are available if not the best for you...

This any good ? ...... https://www.amazon.co.uk/Evolution-Power-Tools-012-0010-Cutter/dp/B08PDLLVPV?th=1

Butt them up and the screws will pull into the studs and bead enough to be able to fill over easily. Take it steady and don't...

There is no particular way and just fit the boards onto the studwork to form the corner and the angle bead can either be nailed or...

You could do it that way or put the window in after reducing the opening. Don't forget insulation in the cavity.

Classic case of the number plate being worth far more than the car.

It would still benefit from doing properly with a defined channel from the right and the benching should be smooth strong mortar...

The right hand channel which directed waste into the main run has been removed up to the chamber wall so now anything that comes down...

Water will flow over it but it will also likely flow under it too and continue leaking out and potentially washing away any bedding or...

Bit hard to say from that image but looks like text on it adjacent to the scraper point so i would wash or wipe it a little to see if...