Recent content by vixerfixer

Hi folks.i have the above saw but need a new armature for it,as the worm gear has stripped.anyone know where i can get one pretty cheap.seen a couple on aliexpress which look the same as mine but the measurements are a bit different.

Thanks peeps for your input.just gonna go 400mm spacing I think with 18mm osb.only a garage at the end of the day‍♂️

It’s a flat roof with a slope.c24 joists.

Evening folks.would 600mm centres be ok for a garage roof,4m span with 8x2 rafters.

Hi folks,am I right in saying the only difference between a cold roof and hybrid roof is just the positioning of the insulation.also could you use dpm for the roof membrane or has it got to be breathable?

Ok,cheers.so would I use one big vent or a few smaller ones.

I’m getting 0.15 with my calculations.would that be correct with the measurements.

Thanks mate,but have to be honest,I’m not the brightest when it comes to this crap,I’m lost‍♂️

Sorry forgot to add pic

Void size is roughly 18” deep x 10ft wide and 14ft long

Hi folks,just putting a false ceiling in the missus salon,but as you can see in the pic,there will be a 28mm gas pipe in the void which is going into the chippy in next shop.what vents will need to be fitted in the ceiling(size and how many).cheers

Thanks mate

Sorry thought it was a header.rather than an rsj from one pillar to other,though 2 timber joists would be ok.

Hi folks,after a bit more advice regarding the above.need to build my header,and was wondering if 2 9x2 joists would be ok from pillar to pillar.was thinking of making it like a ladder with noggins.width of garage is 4m.