Recent content by sparer

New capcitor fitted and it runs the same. I took the motor to bits and the bearings and seals are shot and the windings have overheated so a new (expensive) pump it is. Thanks for the help guys.

Ok. I see now. I just ran the pump again and it started to spin albeit slowly. The windings started to smell so I turned it off quickly. The motor spins by hand (bearings seem a little dry) so I'll order a new capacitor. I'm presuming that that is the best course of action? Thanks

That's interesting. I don't hear the pump move and the fuse blows right away when it should run. So would I be right in saying is that if the pump is stalled or will not start (perhaps due to the capacitor) then the windings will take 20A and blow my 4A fuse? For info, I just tested the unit...

It blows a 4A fuse when the motor starts. Would a failed capacitor do that? I've also noticed some water staining on the motor housing that could have crept onto the windings. I guess I could hook it up to the mains directly and see if I blow a plug top fuse (or trip the breaker).

Hi, I have a wash pump that I think is faulty but I cant find any data on what the resistance of the windings should be. I have a photo of the pump (attached). It is single phase with a L and N and measures 12 ohms. Does that sound low for a 470W pump?

It will scrape off with a fingernail. I won't have the opportunity to leave it for a long time to dry so I'll probably go for danish oil.

Hi, I have a hardwood bannister that has been painted with a varnish that has gone kinda sticky. I suspect it is one of these ronseal exterior products. I'm going to sand it all off but what would be the best product to use to revarnish with. Thanks

I've just spent the day removing old tiles from my bathroom. One wall was lath & plaster and the others were plasterboard. I managed to save the lath & plaster wall because someone had tiled over woodchip so the woodchip came off with the tiles and saved the lath & plaster. The same cannot be...

I have an SMS50T22GB/09 dishwasher that has stopped drying at the end of the cycle. It also wasn't heating the water during the wash cycle but I replaced the heat pump and now the water heats during the cycle but just not for the drying part. Any ideas?

That's interesting

I'd already watched a couple of videos on Youtube about balancing the radiators and had already done this. If that's where JohnD was going, he didn't say so.

Exactly. This is what I was surmising in the original question but thought I would need to change the pump rather than finding a different operating mode.

No, I was asked to close 3 (post #4) but I knew that the 4 x TRVs on the 1st floor were closed already.

I did do it as the rads on the 1st floor had closed TRVs but the 2nd floor rads remained cold until I set the pump to run continuously.

All of the other rads on the system perform well. It was just the highest rads on the 2nd floor which I had an issue with. It seems that a continuously running pump has solved the problem.