Thank you for the replies. Does it mean I can replace one of the 3 crabtree with the single shown in the photo with L1,L2 and Com and then wire up the rest as normal?
Hiya I would like to replace the light switch in the utility for an old industrial type Crabtree switch. The current switch has 3 switches to turn on/off the lights in the utility, an outside light and a kitchen light. I have attached a photo of the current wiring of the switch and the...
Following on from my last post I found some Braided 3 core flex. If the above is possible would this be okay to use?
https://www.kingschandeliers.co.uk/electrical-braided-flex-0.50mm--2-or-3-core/braided-3-core-period-silk-flex-cable-brown-0.50mm/
Hiya, thank you all so much for your replies.
Not sure if it will help any. I've added a couple more photos. The first shows the wire that runs from all 5 arms. It goes into connector (A)that is taped up and another wire comes out from that connector (A) and up to the ceiling connector (B)...
I've been let down by 5 electricians so far who just didn't show and the only one that did tried to prise off one of the staples holding a wire with a penknife and when that didn't work said he would have tape the new wires to the piece.
Could someone tell me if there is a way to test that the...
Hiya, I'm hoping someone can offer some advise.
I have an old light fitting and was wondering if someone could tell me if it needs rewiring? I own a multimeter but I'm not sure how to test to see if the wires are functioning. It's a chandelier type set up with wires connecting to several arms...
There is a gap and I do run a hot wash every month with a washing machine cleaner. It has only been since we pulled everything out to decorate.
I'm starting to wonder if the cause might be because the drainage pipes from the machine haven't been raised enough to empty properly. Are there any...
We have a septic tank but this pipe goes to a grate in the back garden. There is a bit of a whiff in the washing machine was wondering if it was because it wasn't draining properly
Bother, would it work as well if I fitted a McAlpine Adjustable inlet Tubular P Trap with a twin connector? I've been googling while waiting for a reply :-)