Detached bungalow, two windows on the front now have several blown panels.
I need advice on the cost of replacing *all* the double glazing panels vs. ripping out the whole window and installing new frame + new panels.
Window A: 3m x 1.5 m (6 panels)
Window B: 1.7m x 1m (4 panels)
Is it...
Torbeck valves no longer include a polythene filling sleeve, which makes them noisier than before.
I have an old bridge and sleeve unit from an older Torbeck valve. Unfortunately, the bridge part is leaking so I can't just clip it onto the new Torbeck valve.
Wondering if I could snip the...
My Torbeck fill valve was making a screeching noise during filling. So I went to Wickes and bought a replacement (12 quid).
Rather than replace the whole unit, I decided to swap out the top part containing the lever and float.
I unscrewed the blue plastic nut and noticed some specks of muck in...
A couple of my internal doors have sagging levers. I presume, a spring has gone inside.
How do I know on which side of the door has the spring failed?
Or if I need to replace both sides?
And where can I buy replacement springs? Can't see anything at Wickes etc.
Maybe an overflow pipe connector such as this will do the job:
https://www.wickes.co.uk/FloPlast-OS10W-Overflow-System-Straight-Coupling---White-21-5mm-Pack-of-3/p/175676
The section of the cold water tank overflow pipe that is outside the house, exposed to weather, is starting to crack and break up.
I am thinking of cutting back to a couple of inches of sound material and siliconing a small extension section on.
I live in a bungalow, so access is not a problem...
I noticed a leak from the pan connector on my close-coupled WC. My first instinct was to get out the silicone gun and run a bead round the join. This worked for a couple of weeks, but now the drip has returned. My fault for attempting a bodge job.
So I now need to remove and replace the pan...
Thanks for the replies.
The manual override was working when I installed the light all those years ago.
But I threw away the user instructions...I'll try EFLI's tip:
I did not find is an easy fix. It is warm moist air hitting a cold porcelain surface.
After having a bath, I just open the window and wipe down with kitchen towel.
I have an external PIR sensor light that has been turned OFF for several years. Bought at Wickes about 10 yrs ago.
I turned it ON and it worked fine, as expected.
But I needed to override the PIR and have the light ON always.
So I turned the light OFF. Came back 2 mins later and then tried...
As a customer, is now a good time to get replacement windows fitted?
On the plus side, there should be lots of firms looking for work. Maybe prices are low. On the minus side, it may be difficult to get hold of stock. What are the supply chains from the DG manufacturers like at the moment?
I...
Re: Neon. All stock at Wickes had neon.
You can configure the neon operation:
- Neon always ON when power is ON (called Power mode)
- Neon only ON when switch is ON (called Switch mode)
- Neon only ON when switch is OFF (called Locator mode, presumably for finding the switch in the dark)