with your dial going around and around you must take note of the start light to see what sequence it is flashing. whatch it for a while and it will have a clear routine which will diagnose the fault that it thinks it has.
before you go to any trouble, although i agree with the other posts, it seems to me that the best way to diagnose your problem would be to stand it in your house for a couple of days to see if it works there. if it does then you know that the advice is correct. if it doesn't well then you'll...
when rotating the drum by hand, could you hear a clicking sound from the motor with brushes in it? if so it's likely that the armature on the motor has failed and the motor will need to be replaced.
if the motor is o.k. it should run even with as little as 8mm of carbon left. if the ends of the...
have you tried it with a different load?
most modern machines wil refuse to spin if it thinks that the load will be un-balanced. usually bath mats or heavy towels or a dog blanket etc.
it's probably pushing against the glass and causing the lock to be not quite latched properly. drain off any water by gravity through the drain hose and then give the front panel a thump near the lock and it may just open. had this with a recent hoover machine two weeks ago.
if it is back filling then it would normally smell. it sounds more like one of your fill valves has a slight leak. either replace both of them or turn of supply to either overnght and use elimination to work out which one is faulty. they're only a couple of quid each.
if you cant unblock it in situ then try this.
to remove the front panel
1. open the door and remover the wire clamp around outer edge of door seal.
2. undo two screws which hold door lock
3. peel off outer edge of door seal
4.remove kick plate at floor level.
5. undo three 7mm screws at...
if it stopped full of water then the noise you heard may have been your pump on it's last legs. reset the cycle and select drain only and see what happens. if it drains o.k. then it may not be the pump, and fido will probably be right.
i'm sorry but i don't recognise the model number. can you tell me roughly how old it is. it sounds like a metering tank to sump blockage but the remedy is different if it's + 7yrs to if it's 2 to 3 years.
my integrated zanussi jet system 1200 makes a horrendous growling noise during the wash. i know what it is and i can't be bothered to fix it. (you know what they say about a mechanic having the worst maintained car). in my case it's the washer. the noise i've got is the jet system circulation...