I’ve fitted a new Eaton branded Scantronic 9448+ wired panel that a customer supplied to replace the same old one that was 20+ years in service
I’ve found the outdoor siren isn’t working at all and wondered if I can use any brand of wired siren or would this panel only work with selected...
Hi mate, yes thanks for that the problem I’m having is it doesn’t respond to any command I sent to it and it’s supposed to text me back confirming when I’ve made a change to it. There is an app but it says it’s not available in this region, I’m in the UK so I also tried to VPN to change my IP to...
Does anyone know how to test one of these? It’s brand new with a working SIM card from a previously same model but the SIM card holder was broken
I’ve powered it up and it’s got mobile signal with a slow flashing red led and I’ve connected a 12V pc case fan into the following for testing the...
She won’t arm it because she doesn’t want the system at all
She says she doesn’t trust the alarm to work properly and my personal opinion is it’s more to do with there being 2 cats that are quite sick and prone to stress so she doesn’t want to scare them. She’s a very troubled person with a...
Yes
The husband wants the wife to arm the system when she leaves the property
She refuses to use the system and it causes the husband a lot of anxiety over the property being at risk
There’s currently a door contact on the front door set to Entry/Exit
There’s also a PIR in the hallway set...
I’ve had a reply from the Facebook group Texecom Technical Support Group which says
Could you not just set up as a timed set. Say 30secs and then as long as the detection is not say in the hallway that would be ok.
The customer wants the system to automatically arm when they leave the house
This is a request made to me because the customer’s wife refuses to arm the system manually because she didn’t want it installed
So hopefully that makes sense?
In the Installation manual 6.2 Area Modes it looks like changing the zone for the front door from Entry/Exit to Timed Exit could be what I’m looking for and also changing the Exit Settle timer to something longer could be useful too incase the customer opens the door again like if they were just...
I have a customer with a request if possible
When leaving the house the alarm sets, perhaps if no final exit (front door in this case) is retriggered after opening and closing within say 5 mins then it arms
This would allow for situations where they open the door to take parcels or anything...
I have a Pyronix Enforcer demo kit if you want me to test defaulting the engineer code to see if it resets the zones or not let me know
Even if it does reset the zones it’s pretty simple to reprogram them