Exedon's latest activity

Clear picture of area you are dealing with would be useful Your overthinking folding. Dog eared corner like this takes seconds.

First have you tried reseting boiler? As its a system boiler your going to have 3 port motorised valve or 2 two ports. To check if you...

As above but I would recommend the mcalpine FGT150-110 floor gullet Full 110mm bore no water trap very easy to fit We have installed a...

Pipe on left appears to be heating flow so arrow wrong way round pipe on left looks like old cylinder return.

See pic open vented on a H section did one last week even worse but that had a airjec fitted .

Internal easy just a folded dog eared corner external needs bossing or we would just leadburn both. Yes needs either to be turned into...

15mm is fine behind dot and dab it's only 5mm beyond 10mm Plus 15 is what's use for h&c and that goes behind dot and dab as well.

I would try to undo the white plastic part of the waste, looks like an adapter already? It does look like a bath trap would fit, failing...

When we were installing stoves we always had the steel angle frame made in one piece then fixed it with 100mm concrete screws. The...

You could use a coupling, but an elbow already exists.

As a long time new build contractor we would just clip 15mm to the blocks plasterer will be well used to it! You should really have...

Your fga should be fine just select correct fuel!

If motor bearings have gone (nearly always pump side) they can be changed just a strip down job. We now just replace motors to save...

Air admittance valves can only be used if drains are adequate vented elsewhere.

saxton tools are my goto for blades https://www.saxtonblades.co.uk/ Just a DIYer , but i have found their blades last and perform a...