Recent content by blackcloud

Thanks. It's wet wall panels. So the multifit will connect easily. Juat maybe there's an outline/mark of where the previous shower was.

Thanks this is current one

Hi all I am waiting to replace my shower with a new one that is not a 10.8KW a one with a lower KW. But I want to make the new one will fit well when replacing the old one but I dont know if the current one is a Push fit join and if the one I like will fit well? My current one is...

Thanks So that is what it likely could be?

Hi all, Can I ask for peoples thoughts? We are about to move into a new home and I noticed on the inside upper bedroom closest what appears to be water marks? It's a terraced house ground floor and upper. Ground floor is where the bathroom is. All bedrooms upstairs. There was a painter in at...

Hi allwe have these swings for our children and wondering how much poatcrete per swing leg hole do people recommend? I'm thinking 2 x 20kg bags of postcrete for a 1m hole? Or just 1 x 20kg of postcrete for a 1 metre hole...

Hi all I've been looking for ages online for a double kitchen sink with a wide lip sized 95 x 51cm sinks the cut is 92 x 49cm. Or something that would work. This is our current one. If anyone can help with any links I would be most appreciative.

I wanted to buy a new sink but can't find any 95 x 51cm sinks the cut is 92 x 49cm Just been to B and Q and there's none. I also wanted one with a wider lip than the one I have too. If anyone has any links I would be most grateful thanks

Thanks and I just paint it on the exposed chipboard (wood).

Thanks Would this Wood glue do the job? Any other links most appreciated. Thanks https://www.screwfix.com/p/no-nonsense-wood-adhesive-250ml/852kh

Thanks all. Yes I think I will take the advice most have suggested Can I ask where should I seal it or bead it some mentioned? Is beading it the same as putting silicone on it? Where should the silicone go? I'm sure I read to put in two different places?.ie ontop and underneath? What's a goog...

The top left corner of sink lip is slightly raised above worktop which allows the water to come through. But why is this? I press down on it but it pops back up? Everywhere else is tight

Could I buy a new sink with wider lips and get that fitted?

Hi all We got an electrical rewire and they have left thr holes where old spot lights were. So we want to see if there are any fake non electrical spot lights like you see on side of road we can pop in? Just looks ugly if we leave how it is.

You mean just to get a new sink rather than the whole work top? Sinks don't come attached to the worktop do they? You have to seal them in?