Recent content by Bigsosij

I dont really see any reason to stay connected once the alarm is set anyway lol

That is correct ARC takes priority if cloud priority is set to low (default)

His office is probably not using the app module for arc comms. Digi air connected does the app and arc.

U can set cloud priority to high instead of low which assume would do what u want but then would it still send a delayed close signal to the arc ? I dont know

Yeh it kicks you off to send the signal to the ARC

And hes gunna come and do it again in 12 months lol

Im afraid you have indeed had your pants pulled down.

The ARC will likely not police a confirmed alarm if the system is not showing as closed (armed) when it is set up to do so. It is not to validate the transmission path, it is so the arc knows of the system is armed or not so can respond to alarms accordingly. If an arc call fails, an alert will...

It is not an arc check. Arc call start means a call to the arc has been initiated Arc call ok means the call has been completed and the message has been conveyed to the arc - I.e system set/unset. If the alarm is activated and intruder signal will be conveyed to the arc in the same way. It...

When the system is armed, it will send a close signal to the arc. When disarmed will send an open. At default, the output will be programmed as final set all, which means it will only send the close signal if all areas are armed. Your system will never send an open/close signal in this case as...

Or just full set and night set. Then the system should send a close signal the the ARC

Now try arming areas A,B,C,D simultaneously

Have u consulted your installer

Its probably setup to send a test call at that time. Id guess that its not set up to send open/close signals when part armed, only when full set or all areas are set.

You sure you're a technician