Recent content by big-all

note the "for makita"--so not makita ??

make sure you register it with bosch for the extended gtee before you use it to check iff its fake so you can send it back

as an aside as you are now talking bosch just be aware that bosch blue[pro] and bosch green [diy] are not compatable

this would unnerve me " Postage: £1.99 SpeedPAK Standard. See detailsfor postage Located in: 深圳, China" top page rhs

when you look at ebay they can mislead by saying "for bosch" or "genuine for" so check full description with a magnifying glass and dont forget they have there own very similar CE mark that means Chinese exports

just look up "reduced shank drill bits"

iff you think off it a 12.5 or 12.7mm[half inch] drill bit might seem sloppy but your shelf will do no more than sit on the top off the rods even iff you lever on the front edge the most you will get is the back taking up the slack, so perhaps 0.5mm different and you won't see that

in your drawing there seems to be red dotted lines suggesting one level outside another now my thoughts are you wont tend to go bigger as you go up as the narrower below is the pinch point so greater above is pointless so moving to a narrower position above would seem correct but fully a guess ??

general comment the newel must be central to the string it sits on for the handrail and string cap to give central and vertical spindles

we need to put some context here holes in wood are give or take 1mm in general around the shaft always with clearance as wood moves 'expand and contracts drilling for the thread should be around 0.5mm less than screw size in general the countersunk head is the only real point off gteed contact...

ghost trains are to do with the procedure for closing a line or station you have to make a case and show what alternative ways people can complete the same journeys often requiring a permenant replacement service like a taxi on demand for the journey [look up newhaven marine station ] or a bus...

my choices are hammer off and hammer on and low gear for screwing never use the clutch

a bit strong really [unless your comments are rhetorical ]entering a vote must conform with requirements as in clear'and to requirements "spoiling " will mean non-compliant so off no interest or offence ??

i would not worry iff you remove say 1mm because the /\ is so shallow the gap will be perhaps 1/6th off a millimetre so surface finnish will fill it

would be an interesting conversation when the repair engineer says "it says in the manual not to be installed next to a heat source " as he thinks about packing his bag and walking away as he has a get out clause ??